lang
News新闻资讯
Company News
HOW TO CLEAN DROPS ON THE MESH BELT?
January 12,2021 By Changda Textile Views:
Tools：heat gun, air hose, cotton fabric, alcohol, copper wire brush, teasing needle, vacuum cleaner.
Location：After the machine is stopped, locate the mesh belt with drops at a place where the front and back sides of the mesh belt can be breathable. Normally, the belt should be under tension, when chearing the drops. First, locate to drops with large area, but easy to clean. Then, focus on drops that are difficult to clean.Finally, inspect the mesh belt overall.
Notice：he air outlet of the heat gun should be 5-10cm away from the mesh belt, and move repeatedly around the drops on the mesh belt. It is forbidden to spray against a point of the belt for a long time, to avoid shrinkage and deformation of the mesh belt Before the drops start to soften and has not totally melted, use pliers with flat jaws to moderately clamp the semi melted drops, and then pull it out, during this process, hot air can be intermittently blown to the contact position between the melt and the mesh belt. The water used is 80 degrees, and it is cleaned under a certain pressure. Avoid long time drops, which is too consolidate to clean.
Cleaning method：Use heat gun, with 170 ℃ to soften the drops to the shape of oil, make repeated movements around the drops on the mesh belt. Suck it with a vacuum cleaner. Blow it with the air hose several times until the monomer oil between the monofiamlent of the mesh belt obviously reduced.Pour in alcohol and wipe it repeatedly with cotton fabric. Dry the cleaned postion of the belt with an air hose.
Reasons for dropping：The screw loses pressure, material supply shortage, malfunctions, the raw material contains water. raw materials, process problems, spinneret problem.z
Location：After the machine is stopped, locate the mesh belt with drops at a place where the front and back sides of the mesh belt can be breathable. Normally, the belt should be under tension, when chearing the drops. First, locate to drops with large area, but easy to clean. Then, focus on drops that are difficult to clean.Finally, inspect the mesh belt overall.
Notice：he air outlet of the heat gun should be 5-10cm away from the mesh belt, and move repeatedly around the drops on the mesh belt. It is forbidden to spray against a point of the belt for a long time, to avoid shrinkage and deformation of the mesh belt Before the drops start to soften and has not totally melted, use pliers with flat jaws to moderately clamp the semi melted drops, and then pull it out, during this process, hot air can be intermittently blown to the contact position between the melt and the mesh belt. The water used is 80 degrees, and it is cleaned under a certain pressure. Avoid long time drops, which is too consolidate to clean.
Cleaning method：Use heat gun, with 170 ℃ to soften the drops to the shape of oil, make repeated movements around the drops on the mesh belt. Suck it with a vacuum cleaner. Blow it with the air hose several times until the monomer oil between the monofiamlent of the mesh belt obviously reduced.Pour in alcohol and wipe it repeatedly with cotton fabric. Dry the cleaned postion of the belt with an air hose.
Reasons for dropping：The screw loses pressure, material supply shortage, malfunctions, the raw material contains water. raw materials, process problems, spinneret problem.z
ADDRESS：No. 1 Huatong Road, Development Zone, Chengguan Town, Taihe County, Fuyang City, Anhui Province, China.
CALL US ON：+9053 9384 7765
MAIL US：seles@sinochanda.com
Copyrights © All Rights Reserved by Anhui Changda Textile Co., Ltd. Anhui ICP Preparation No. 18010119 Support: Hefei website construction
